Updated Feb-2023 Official licence for NSE6_FWF-6.4 Certified by NSE6_FWF-6.4 Dumps PDF
Grab latest Amazon NSE6_FWF-6.4 Dumps as PDF Updated on 2023
NEW QUESTION 17
Refer to the exhibit.
What does the asterisk (*) symbol beside the channel mean?
- A. Indicates channels that cannot be used because of regulatory channel restrictions
- B. Indicates channels that will be scanned by the Wireless Intrusion Detection System (WIDS)
- C. Indicates channels that can be used only when Radio Resource Provisioning is enabled
- D. Indicates channels that are subject to dynamic frequency selection (DFS) regulations
Answer: C
NEW QUESTION 18
Which statement describes FortiPresence location map functionality?
- A. Provides real-time insight into user movements
- B. Provides real-time insight into user usage stats
- C. Provides real-time insight into user online activity
- D. Provides real-time insight into user purchase activity
Answer: B
Explanation:
This geographical data analysis provides real-time insights into user behavior.
NEW QUESTION 19
Which of the following is a requirement to generate analytic reports using on-site FortiPresence deployment?
- A. DTLS encryption on wireless traffic must be turned off
- B. Wireless network security must be set to open
- C. SQL services must be running
- D. Two wireless APs must be sending data
Answer: C
NEW QUESTION 20
When using FortiPresence as a captive portal, which two types of public authentication services can be used to access guest Wi-Fi? (Choose two.)
- A. Hardware security token authentication
- B. Software security token authentication
- C. Short message service authentication
- D. Social networks authentication
Answer: C,D
NEW QUESTION 21
Which two configurations are compatible for Wireless Single Sign-On (WSSO)? (Choose two.)
- A. A VAP configured to authenticate locally on FortiGate
- B. A VAP configured to authenticate using a radius server
- C. A VAP configured for captive portal authentication
- D. A VAP configured for WPA2 or 3 Enterprise
Answer: B,D
Explanation:
In the SSID choose WPA2-Enterprise authentication.
WSSO is RADIUS-based authentication that passes the user's user group memberships to the FortiGate.
NEW QUESTION 22
Which two statements about distributed automatic radio resource provisioning (DARRP) are correct? (Choose two.)
- A. DARRP measurements can be scheduled to occur at specific times.
- B. DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.
- C. DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.
- D. DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.
Answer: A,D
Explanation:
According to Fortinet training: "When using DARRP, the AP selects the best channel available to use based on the scan results of BSSID/receive signal strength (RSSI) to AC" and "To set the running time for DARRP optimization, use the following CLI command within the wireless controller setting: set darrp-optimize {integer}. Note that DARRP doesn't do continuous spectrum analysis..."
NEW QUESTION 23
Which two phases are part of the process to plan a wireless design project? (Choose two.)
- A. Installation phase
- B. Site survey phase
- C. Hardware selection phase
- D. Project information phase
Answer: A,B
Explanation:
Reference:
https://www.automation.com/en-us/articles/2015-2/wireless-device-network-planning-and-design
NEW QUESTION 24
Which two phases are part of the process to plan a wireless design project? (Choose two.)
- A. Project information phase
- B. Site survey phase
- C. Installation phase
- D. Hardware selection phase
Answer: A,B
NEW QUESTION 25
When configuring Auto TX Power control on an AP radio, which two statements best describe how the radio responds? (Choose two.)
- A. When the AP detects any other wireless signal stronger that -70 dBm, it will reduce its transmission power until it reaches the minimum configured TX power limit.
- B. When the AP detects any wireless client signal weaker than -70 dBm, it will reduce its transmission power until it reaches the maximum configured TX power limit.
- C. When the AP detects any interference from a trusted neighboring AP stronger that -70 dBm, it will reduce its transmission power until it reaches the minimum configured TX power limit.
- D. When the AP detects PF Interference from an unknown source such as a cordless phone with a signal stronger that -70 dBm, it will increase its transmission power until it reaches the maximum configured TX power limit.
Answer: A,B
NEW QUESTION 26
Refer to the exhibit.
If the signal is set to -68 dB on the FortiPlanner site survey reading, which statement is correct regarding the coverage area?
- A. Areas with the signal strength weaker than -68 dB are highlighted in orange and red to indicate that no signal was propagated by the APs.
- B. Areas with the signal strength weaker than -68 dB are cut out of the map
- C. Areas with the signal strength equal or stronger than -68 dB are highlighted in multicolor
- D. Areas with the signal strength equal to -68 dB are zoomed in to provide better visibility
Answer: A
NEW QUESTION 27
Refer to the exhibits.
Exhibit A
Exhibit B
A wireless network has been created to support a group of users in a specific area of a building. The wireless network is configured but users are unable to connect to it. The exhibits show the relevant controller configuration for the APs and the wireless network.
Which two configuration changes will resolve the issue? (Choose two.)
- A. Disable intra-vap-privacy for the Authors vap-wireless network
- B. For both interfaces in the wtp-profile, configure set vaps to be "Authors"
- C. Increase the transmission power of the AP radio interfaces
- D. For both interfaces in the wtp-profile, configure vap-all to be manual
Answer: A,D
NEW QUESTION 28
Which two statements about background rogue scanning are correct? (Choose two.)
- A. Background rogue scanning requires DARRP to be enabled on the AP instance
- B. A dedicated radio configured for background scanning can support the connection of wireless clients
- C. A dedicated radio configured for background scanning can detect rogue devices on all other channels in its configured frequency band
- D. When detecting rogue APs, a dedicated radio configured for background scanning can suppress the rogue AP
Answer: A,C
NEW QUESTION 29
Which two roles does FortiPresence analytics assist in generating presence reports? (Choose two.)
- A. Comparing current data with historical records
- B. Reporting potential threats by guests on site
- C. Gathering details about on site visitors
- D. Predicting the number of guest users visiting on-site
Answer: C,D
NEW QUESTION 30
What is the first discovery method used by FortiAP to locate the FortiGate wireless controller in the default configuration?
- A. Multicast
- B. Broadcast
- C. Static
- D. DHCP
Answer: C
NEW QUESTION 31
As standard best practice, which configuration should be performed before configuring FortiAPs using a FortiGate wireless controller?
- A. Set the wireless controller country setting
- B. Create a custom AP profile
- C. Create wireless LAN specific policies
- D. Preauthorize APs
Answer: B
NEW QUESTION 32
Which factor is the best indicator of wireless client connection quality?
- A. The channel utilization of the channel the client is using
- B. Downstream link rate, the connection rate for the AP to the client
- C. The receive signal strength (RSS) of the client at the AP
- D. Upstream link rate, the connection rate for the client to the AP
Answer: C
Explanation:
SSI, or "Received Signal Strength Indicator," is a measurement of how well your device can hear a signal from an access point or router. It's a value that is useful for determining if you have enough signal to get a good wireless connection.
NEW QUESTION 33
What is the first discovery method used by FortiAP to locate the FortiGate wireless controller in the default configuration?
- A. Multicast
- B. Static
- C. Broadcast
- D. DHCP
Answer: D
NEW QUESTION 34
Refer to the exhibits.
Exhibit A
Exhibit B
The exhibits show the diagnose debug log of a station connection taken on the controller CLI.
Which security mode is used by the wireless connection?
- A. WPA3 Enterprise
- B. WPA2 Enterprise
- C. Open, with radius MAC filtering
- D. WPA2 Personal and radius MAC filtering
Answer: B
Explanation:
Best security option is WPA2-AES.
NEW QUESTION 35
Part of the location service registration process is to link FortiAPs in FortiPresence.
Which two management services can configure the discovered AP registration information from the FortiPresence cloud? (Choose two.)
- A. FortiSwitch
- B. FortiAP Cloud
- C. AP Manager
- D. FortiGate
Answer: B,D
Explanation:
FortiGate, FortiCloud wireless access points (send visitor data in the form of station reports directly to FortiPresence)
NEW QUESTION 36
......
Latest NSE6_FWF-6.4 Exam Dumps Fortinet Exam from Training: https://prepcram.pass4guide.com/NSE6_FWF-6.4-dumps-questions.html